Rugged Ridge 3-Inch Double Rear Tube Bumper, 07-14 Jeep Wrangler - Manual (Page 2)

3. Insert Bumper into frame rails (Figure 3a). Install left plate and right plate on the outside of
the frame rails with the 12mm bolt and washer (Figure 3b). Leave bolts loose until all 4 are started.
Bumper can adjust forward to achieve a tight fit to the body, or adjust rearward to provide clearance
for the optional reciver hitch or tow hook. Once position of the bumper is finalized, tighten bolts.
Figure 3a
4. Attach Filler Panel to the horizontal tabs in the Left Plate and Right Plate using the 6mm Hex
Head Screws, 6mm Washers, and 6mm Lock Nuts. Leave Fasteners Loose until both sides are
installed. Adjust placement of Filler Panel until desired look is achieved, then tighten
screws (Figure 4).
Page 2 of 2
Figure 4
Figure 3b
Omix-Ada Inc.
460 Horizon Dr. Suite 400
Suwanee, Georgia 30024
Congratulations on the purchase and installation of a quality Rugged Ridge product!
© Copyright Omix-Ada 2008