Rugged Ridge RRC Mount, XHD Modular Front Bumper, 76-14 Jeep CJ and Wrangler - Manual

11540.18
Jeep
®
JK Wrangler Modular HD Front Bumper RRC Hoop
Contents:
1. RRC Hoop (1)
1. If installing as part of a new installation, place center section of bumper onto frame rails, but do not
yet attach. If RRC Hoop is being added to an existing installation, remove existing Hoop and D-Rings
from Center Section. Center Section should be sitting on the frame rails, but not attached (Figure 1a).
Place RRC Hoop over Center Section (Figure 1b) and align 8 holes on top and 8 holes on front (Figure 1c).
Figure 1a Figure 1b Figure 1c
2. Install 8 top bolts ( provided with the Center Section) through the RRC Hoop and into the Center
Section (Figure 2a). Do not tighten bolts yet. Install 8 front bolts (provided with Center Section)
through the RRC Hoop and into the Center Section (Figure 2b).
Page 1 of 2
1
Figure 2a Figure 2b