Rugged Ridge Storage Ends, XHD Modular Front Bumper - Manual

2007 Jeep
®
JK Wrangler Modular XHD Front Bumper Storage Ends
Contents:
1. Left Storage End (1)
2. Right Storage End (1)
1. Storage Ends are easier to install with the Center Section of Modular XHD Bumper off of the vehicle,
but can be installed with the Center Section already installed. If Storage Ends are replacing
previously installed Stubby Ends (Figure 1a), remove them so that empty ends remain (Figure 1b).
2. Position Storage Ends to the ends of the Center Section, aligning the studs in the Storage Ends with
the holes in the sides of the Center Section (Figure 2a). Insert the studs in the Storage End into the
holes in the Center Section and secure them with the nuts that came with the Center Section.
Page 1 of 2
Figure 1b Figure 1a
Remove
11540.22
NOTICE: Failure to lock lids of XHD Storage Ends could result in loss of lids and/or damage to vehicle components.
Always double check to make sure lids are properly locked before operating the vehicle.