Rugged Ridge Side Marker Light Euro Guards, Stainless Steel, 07-14 Jeep Wrangler - Manual

11231.12 (Black)
11142.12 (Stainless Steel)
Jeep
®
JK Wrangler Side Marker Euro Guards
Contents:
Side Marker Euro Guards (2)
1. Gain access to the side marker light. First, pull back the inner fender liner to expose the
back of the side marker light. It needs to be pulled over a tab (Figures 1a and 1b). Next, use
a small allen wrench to push in the center of the plastic rivet that holds the fender flare to the light
(Figure 1c). It sometimes takes considerable force to release this. Once the center has been
pushed through, the rivet can be pulled out toward the wheel.
Figure 1a Figure 1b Figure 1c
2. Remove bulb from light housing by twisting and pulling (Figure 2a). Push on tab at top of side
marker housing to release housing from inner fender (Figure 2b). Pull light housing out of bottom
of fender flare (Figure 2c). It may help to have another person pull the inner fender liner and the
flare apart while removing the light.
Page 1 of 2
Figure 2a Figure 2b Figure 2c