Rugged Ridge Gas Tank Skid Plate, 87-95 Jeep Wrangler (YJ) - Manual

18003.21
87-95 YJ GAS TANK SKID PLATE
Page 1 of 3
NOTE: Perform installation when gas gauge reads
below 1/4 tank. A lighter gas tank will be easier to
manage. Also, have a partner handy to assist with
the removal and installation of the tank.
WARNING: When working near gasoline, always be cautious not to have any heat or flame generating
device as this could result in combustion and cause injury or death. Always keep a fire extinguisher handy
when working with combustible fluids.
1. Disconnect battery terminals before beginning installation of this product. Disconnect negative terminal
first making sure not to contact the positive terminal with the tool being used.
2. Remove the gas cap from the vehicle to relieve the pressure inside the
tank. Remove the fuel filler assembly by first removing the 6 screws holding
the filler neck in position. For easier access, remove two screws holding the
license plate in place. Save these screws, they will be used to reinstall filler
neck. NOTE: It is also possible to unhook filler hoses directly from gas tank.
3. Remove the nut from the bracket holding the exhaust pipe in place on
the passenger side of the vehicle. This will allow movement in the exhaust
pipe during removal of the tank from the vehicle.
4. Position floor jack centered beneath the gas tank. Remove the 7 nuts
holding the gas tank and the OE skid pan to the vehicle. Save these nuts as
they will be used to reinstall the gas tank. Do not remove the nuts securing
the gas tank to the OE skid pan.
Contents:
1. YJ Gas Tank Skid Plate (1)