Actiontec electronic GT704WR - Manual (Page 8)

4
Actiontec 54 Mbps Wireless Cable/DSL Router User Manual
5
Chapter 1 Introduction
Cable/DSL Port
The Cable/
DSL port is used to connect the Router to an Ethernet cable/
DSL modem.
Reset Switch
Depressing the Reset switch for one or two seconds will power cycle the Router
(similar to unplugging and then plugging in the Router’s Power cord). To
restore the Router’s factory default settings, depress and hold the Reset switch
for approximately 15 seconds. The reset process will start about
10 seconds after
releasing the switch.
Power Port
The Power port is used to connect the Power cord to the Router.
N
Warning: Do not unplug the Power cord from the Router dur-
ing the reset process. Doing so may result in permanent damage
to the Router.