beautypg.com

Rugged Ridge 3-Inch Round Tube Side Steps, Black, 07-14 Jeep Wrangler (JK) User Manual

Installation instructions

background image





PARTS LIST

1 Driver Side Bar

4

10mm Lock Washers

1 Passenger Side Bar

4

10mm Fender Washers

1 Driver Side Front Mounting Bracket

8

8mm X 25 Hex Bolts

1 Driver Side Rear Mounting Bracket

8

8mm Lock Washers

1 Passenger Side Front Mounting Bracket

8

8mm Flat Washers

1 Passenger Side Rear Mounting Bracket

8

6MM X 25MM Allen Bolts

1 4mm Allen Tool

8

6MM Nylock Nuts

4 10mm X 35mm Hex Head Bolts

8

6.5mm ID x 18mm OD x 1.6mm Flat Washers

4 10mm Nut Plates

8

6.3mm ID x 23mm OD x 3.2mm Flat Washers


















PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ

INSTRUCTIONS CAREFULLY.

2. Insert a nut plate into the frame opening on the front driver side with the nut facing up,

(Figure 1).

3. Locate two factory holes on the front driver side pinch weld. Attach the Front Driver Side

Mounting Bracket to the pinch weld using the included (2) 6-1.00mm x 25mm Allen Bolts, (2)
6mm Nylock Nuts, (2) 6.5mm ID x 18mm OD x 1.6mm Flat Washers (for the out side) and
use (2) 6.3mm ID x 23mm OD x 3.2mm Flat Washers (for the inside against the bracket)
(Figure 2). Do not tighten at this time.

4. Attach the Front Driver Side Mounting Bracket to the side panel using the included (1) 10-

1.50mm x 35mm Hex Head Bolt, (1) 10mm Lock Washer, and (1) 10mm Fender Washer,
(Figure 2). Do not tighten at this time.

5. Repeat steps 2-4 for Rear Driver Side Mounting Bracket. NOTE: For the 2007 JK you will

only use (1) 6-1.00mm x 25mm Allen Bolt, (1) 6mm Nylock Nut, (1) 6.5mm ID x 18mm OD x
1.6mm Flat Washer (for the out side) and use (1) 6.3mm ID x 23mm OD x 3.2mm Flat
Washer (for the inside against the bracket) to attach rear bracket to pinch weld, (Figure 3).
For the 2008 JK you will use (2) 6mm Nylock Nuts and related hardware (Figure 4).

Page 1 of 1 07/16/08 Rev1 (DP

)

INSTALLATION INSTRUCTIONS

SIDE BARS - 3” ROUND AND OVAL

2007-08 JEEP WRANGLER 2 DOOR

PART NUMBER 11590.05/11591.05/11593.05

4) Nut Plates

Longer Passenger

Side Rear Bracket

Longer Driver Side

Rear Bracket

Shorter Driver Side Front Bracket

Shorter Passenger Side Front Bracket

Note: Pay

Close

Attention to

the overall

length of the

Brackets