Rugged Ridge Tail Light Euro Guards, Black, 07-14 Jeep Wrangler - Manual (Page 2)

Step2: Insert the Large 2” replacement screw through the front side of the
new H/D taillight guard starting with the outer top mounting hole.
Place one of the Black Plastic Lens Spacer over the large 2” screw from
the back side of guard (Fig.3). Insert screw and assemble into outer top
hole (Fig.4).
Fig.3 Fig.4
Step3: Start outer top screw but do not tighten. Leave loose to allow for the fitment
of the remaining 3 screws and spacers. Move to the inner top screw location
and insert a Black Plastic Lens Spacer behind guard and into lens mounting
opening (Fig.5). Insert Smaller 2” Philips Head Screw through the front of
the guard and into the lens assemble (DO NOT TIGHTEN). Follow the same
procedure for the outer lower and inner lower mounts. Remember that the
larger 2” Philips head screws go to the outside. Confirm fitment of cover and
proper placement of Black Plastic Spacers prior to tightening (Fig.6).
Fig.5 Fig.6