Rugged Ridge Headlight Euro Guards, Black, 07-14 Jeep Wrangler - Manual (Page 2)

Step(4)
Gently pull the grille forward (fig. 4). If desired the grille can be removed by disconnecting the two front
turn signal bulbs and gently popping the grille from its lower retainer clips. (Fig. 5 – 6)
(Fig.5) (Fig.6)
Step(5)
Remove the original headlamp retainer ring using a T15 torx head screwdriver. Do Not Discard Screws as
they will be reused. (Fig. 7). With ring removed place new Euro Guard retainer ring over lamp , aligning the
tabs as shown (Fig. 8). Please note that the headlamps have keyed tabs molded into the rear of the light.
This insures that the light is properly aligned when installed. The new guards are the same part for both left
and right sides and can only be mounted in one direction.
(Fig.7) (Fig.8)
Step(6)
With the ring in place reinstall the torx head screws saved in step 5. The ring has been designed with a very
tight fit around the lamp and may not slide easily over your lens. If this happens, simple insert one screw
into the outer top mounting tab and loosely tighten. Now insert the remaining four screws insuring that the
lamp is correctly positioned into assemble tabs. With all screws in place start tightening each screw a little
at a time until the Euro Guard retainer ring is pulled over the lamp and is secured to the lamp assemble
base. Tighten all screws with the T15 torx head screw driver. (Fig. 9 )
(Fig.9)