Technical specifications, Ak m80/86 specifications, Physical – APTech Series AK M86 User Manual
Page 5: Pressure and flow, Ak m80/86 facility requirements
AK M80/86 Manual
P/N 00-15000010 Rev 3
3. TECHNICAL SPECIFICATIONS
3.1.
AK M80/86 Specifications
3.1.1. Physical
Dimensions are approximately 6 inch wide by 10 inch high by 8-1/2 inch deep
Weight is approximately 9 lbs.
Mounting is by 4 each 1/4 inch diameter screws
3.1.2. Pressure and Flow
3500 psig maximum inlet pressure
250, 150, 100, 60, or 30 psig maximum outlet pressure options (specified when ordered)
75 slm nitrogen maximum flow at 200 psig minimum inlet pressure (depending on line regulator
outlet pressure setting)
3.2.
AK M80/86 Facility Requirements
The following is needed to install the AK M80/86 manifold at the users facility.
Horizontal strut channel or wall with anchor bolts
1/4 inch diameter, hex head type screws (1/4-20 or 1/4-28 thread acceptable)
The following is required for proper operation of the equipment:
Check valve for installation between cylinder and regulator inlet port
Manual valve for installation between cylinder and check valve
Appropriate purge and vent system for hazardous gases
Relief valve for installation on crossover regulator low pressure port
Relief valve for installation on line regulator low pressure port
Page 5 of 14