Martin Universal Design 92-3032 DeluxeFrench Sketchbox Easel - Manual

This french sketchbox easel is 95% assembled. All one must do is set-up the legs and open the
sketchbox for proper use and handling.
92-3032 DeluxeFrench Sketchbox Easel Assembly Instructions
4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:(313)895-0700 / Fax:(313)895-0709
E-mail: [email protected] • www.MartinUniversalDesign.com
1. After removing Sketchbox Easel from box, remove styro-foam
sides and discard.
2. Begin by loosening wing nut [A] found under top rear edge of
easel sketchbox. After loosening wing-nut [A], swing center leg
outward while swinging hinged support [B] out until it stops
against support plate. Tighten wing-nut [A] to secure. See FIG 1.
3. Loosen wing-nut [C] and swing middle section of center leg up
until it stops against support plate. Tighten wing-nut [C] to
secure. See FIG 2.
4. Finish center leg assembly by loosening wing-nut [D] and sliding
out the lower section of leg completely. Tighten wing-nut to
secure. See FIG 3.
5. Assemble Side Legs by slightly loosening wing-nut [E] and
pulling legs away from easel box by unsnapping it from the
easel sketchbox at [F] Please Note: You may have to pull
firmly. See FIG 4 and review FIG 4A.
Turn page over to complete assembly instructions.
Assembly Instructions
A
B
FIG 1
C
A
B
FIG 2
FIG 3
D
C
B
FIG 4
E
F
FIG 4A
F
pg.1
IMPORTANT
If you have difficulty assembling your easel or need customer service assistance.
Please call: Martin Universal Design, Inc. Customer Service Hot Line at
1-800-366-7337. If you need additional parts, it is not necessary to contact your
dealer, our Customer Service Rep. will forward them to you immediately.