Martin Universal Design 92-3014 BOLOGNA STUDIO EASEL - Manual

92-3014 • BOLOGNA STUDIO EASEL
ASSEMBLY/SET-UP INSTRUCTIONS
Martin/F. Weber Co.
4444 Lawton Avenue, Detroit, MI 48208 USA
Tel:(313)895-0700 • Fax:(313)895-0709
E-mail:[email protected]
www.MartinUniversalDesign.com • www.weberart.com
STEP 1. Begin by removing easel assembly, Upper Canvas Support, two Large Lower Canvas Support and the one
Channelled Center Column from carton. Set pieces aside.
FIG. 1
FIG. 5
[A]
Upper Canvas Support
[B] Large
Canvas Supports
(2 each)
[C]
Side Channelled Center Column
STEP 2. Begin by Assembling the lower half of easel
by securing the upper & lower rear legs. (these pieces are
already attached to easel assembly) secure together using
the bolt, washer and female knobs.
First insert bolt through lower inside hinged leg then
through upper channelled hinged leg.
Secure with washer and knob.
See FIG 2 for illustration.
REPEAT WITH OTHER LEG.
FIG. 2
lower inside hinged leg
upper channelled
hinged leg
Knob
Bolt
Washer
Page 1
09/2008 RPI