Martin Universal Design 92-3014 BOLOGNA STUDIO EASEL - Manual (Page 2)

92-3014 • BOLOGNA STUDIO EASEL
ASSEMBLY/SET-UP INSTRUCTIONS
Martin/F. Weber Co.
4444 Lawton Avenue, Detroit, MI 48208 USA
Tel:(313)895-0700 • Fax:(313)895-0709
E-mail:[email protected]
www.MartinUniversalDesign.com • www.weberart.com
STEP 3. Lower portion of easel assembly should no
look like FIG 3. for proper assembly of upper/lower legs. FIG. 3
lower inside hinged leg
upper channelled
hinged leg
STEP 4. Attaching Channelled Center Column (part
C) into Easel Assembly. Tilt Easel assembly to allow the
center column [C] to be inserted down in between the two
center column supports.
PLEASE NOTE: The flat end
of the Center Column is the bottom end of the Center
Column. This end sits flush with the bottom of the
Center Column Supports.
NOTE: The knob found on the rear of the Easel
assembly is to secure Center Column at desired
extended height.
SEE FIG 4
FIG. 4
Center Column
with Flat end
inserting first
Center Column
supports
Adjustment knob to
secure center column
at desired height.
STEP 5. Attach one of the Lower Canvas Supports to
the Center Column Support by sliding the Lower Canvas
Support up from the bottom, making sure the supports
slide in-between the guides on the rear of the canvas
support. Se FIG 5
NOTE: Once is desired position tighten the knob to
secure. See FIG 5B FIG. 5
FIG. 5B
Page 2
09/2008 RPI