Martin Universal Design 92-2100 MURANO Professional Studio Easel - Manual (Page 4)

Pg. 4
Angle Adjustment:
Loosen knobs on side leg angle supports and tighten at
desired angle.
Height Adjustment of Center Column:
Unlock loop-pull on lower canvas support, adjust to de-
sired height and release loop-pull.
Martin/F. Weber Co. • 4444 Lawton Avenue, Detroit, MI 48208 USA
Tel:(313)895-0700 • Fax:(313)895-0709 • E-mail:[email protected]
www.MartinUniversalDesign.com • www.weberart.com
Made in China
Created June 06 RPI
If you have any problems with assembling this
easel, please call (313)895-0700 or e-mail us at
[email protected].
Thank You.
Enjoy your Easel!
STEP 19.
Side Arm Frame Assembly to Base Attachment
With Base laying face-up on
carpeted floor, line up notched grooves on bottom ends of
the Side Arm Frame Assembly with wooden supports on
base. Secure with Knob, washer and 6x35mm bolt [ID#I].
Insert bolt through inside side of side arm through base
foot, then back through other side of side arm. Attach
washer and then secure with knob.
Repeat with other side.
See FIG 19.
NOTE: This knob can be loosened when angle of
easel needs to be adjusted. Re-tighten when desired
angle is achieved.
STEP 20.
Side Leg Angle Support to base assembly
Attach side leg angle support [ID#9] to base using one
6x45mm wood screw [ID#D]. Repeat with other side.
Tighten with phillips screwdriver [ID#Y].
See FIG 20.
FIG 19
3
1
FIG 20
1
9
Y
D
Easel should
like photo to
right after
correct
assembly.
92-2100
Murano
Professional
Studio Easel