Martin Universal Design 92-AE122 Torino Aluminum Easel - Manual (Page 2)

Martin/F. Weber Co., Detroit, MI USA
www.weberart.com
Email: [email protected]
Made in China
Step 5.
Before attaching the lower canvas support [C] to the
easel begin by taking [1] Knob [B] and remove T-bolt
by un-screwing from Knob. See FIG 3.
Step 6.
Insert T-Bolt through hole from the back of canvas tray.
See FIG 4. Continue by sliding flat end of T-Bolt up into
groove of center column. Complete by attaching knob
[B] to T-bolt on front of lower canvas tray. See FIG 5.
REPEAT with Upper Canvas Support, only this time
sliding T-bolt through top end of easel, similar to FIG 5.
NOTE: When needing to adjust the position of the up-
per canvas support or lower canvas tray, loosen the
knobs and move them to the desired position.
Re-tighten to secure.
Step 7.
Double check all nuts and knobs making sure all
are tightened. Your easel is now ready to use.
See FIG 6.
FIG 5
Revised 09/06
Torino
Aluminum Easel Assembly Instructions (page 2)
Item No. 92-AE122
Palette Holders
Lower
Canvas
Support [C]
FIG 3 T-Bolt
Knob
Side View of Lower Canvas Tray
Insert T-Bolt through
back of Canvas Tray
FIG 4
End view of center column of easel & lower canvas tray
[B]
FIG 6
lower can-
vas tray
upper can-
vas support
If you have any questions or difficulties
assembling this easel.
Please call our Customer Service Hotline
at: (313)895-0700
[B]