Martin Universal Design U-DS31W Drawing Table - Manual (Page 2)

U-DS31W Drawing Table Assembly Instructions
4444 Lawton Ave., Detroit, MI 48208 USA
Tel: 313.895.0700 • Fax: 313.895.0709 • E-mail: [email protected]
Open carton and remove all contents. Check to make sure carton contains:
A. [1] Folded Drawing Table B. [1] Hardware Pack (taped to the drawing table) C. [2] Base-Feet
STEP 1. Begin by taking folded drawing table out of
carton. See image below.
Hardware pack
STEP 3. Attach Base-feet to table by using [1]
washer and [1] Allen-screw. Repeat with other
base-foot.
STEP 2. Remove the hardware pack which is
taped to the drawing table base. Remove the [2]
base feet from the carton. Set aside.
STEP 4. Table should now look like image below.
Base-feet now attached.
Washer
Allen-Screw
STEP 5. Loosen Large Black knobs on table base
to allow height adjustments
STEP 6. Loosen Lever on table base to allow for
tilt adjustments.
Pg. 2
created 08/27/06 RPI