Minka Group F521-WHF - Manual (Page 19)

11
WARNING: Shut of the power supply before removing or replacing lamp. In handling of halogen bulb, care should be taken not to touch it with
your bare hands. Oil residue will shorten the life of the halogen bulb. If you accidentally come into contact, wipe thoroughly with a clean,
lint-free, cotton cloth. Allow the bulb to cool off for 10 minutes before changing the bulb. Use light bulb in accordance with the fan's specification.
TO REDUCE THE RISK OF FIRE DO NOT EXCEED MAXIMUM WATTAGE RATING.
ATTENTION: The Energy Policy Act of 2005 requires this fan to be equipped with a 190 watt limiting device. If lamping exceeds 190 watts, the
ceiling fan's light kit will shut off automatically.
If you do not plan to install the light kit with your fan at this time, skip step 1 & 2.
Step 1. Install the 100w halogen bulb (included).
Step 2. Raise glass shade up against bottom of fan housing and secure it to the fan by turning the glass shade clockwise until snug. DO NOT
OVERTIGHTEN. (Fig. 20)
Step 3. If installing the optional aluminum cover, make sure is securely tighten. (Fig. 21)
NOTE: Please remove the bulb before installing the optional switch cup cover.
INSTALLING THE LIGHT BULB & GLASS SHADE