F521-e-p-17, Installing the light plate – Minka Group F521-WHF User Manual

Page 18

Text mode
Original mode

Fig 19

INSTALLING THE LIGHT PLATE

NOTE: Before starting installation, make sure power is turned off at the circuit breaker.

1. Remove 1 of 3 screws from the light kit mounting plate and loosen the other 2 screws. (Do not
remove)

2. Raise and hold the light plate close to the light kit mounting plate and proceed to do the wire
connections. Connect the white wire connectors from the light plate and fan, follow the same
procedure with the black wire connectors. (Fig. 19)

3. Place the key holes from the light plate over the 2 screws previously loosened from the light kit
Mounting Plate, turn light plate until it locks in place at the narrow section of the key holes. Secure
by tightening the 2 screws previously loosened and the one previously removed. (Fig. 19).

SCREWS

CONNECTORS

LIGHT PLATE

LIGHT KIT

MOUNTING

PLATE

This manual is related to the following products:

F521-ORB