Minka Group F594-ORB - Manual (Page 18)

11
OPERATING THE REMOTE CONTROL/WALL CONTROL
Restore Power to Ceiling Fan.
A. Buttons:
These buttons are used to set the fan speeds as
follows;
= Low Speed
= Medium Speed
= High Speed
B. Button:
This button turns the fan off.
C. Button:
These buttons turn the light ON or OFF and also
control the brightness settings of the light. The
following
instructions apply to ceiling fans that feature a
DOWN light ( button) only or ceiling fans that
feature an UP light ( button) and a DOWN
light ( button) that are controlled independent
of each other.
Press and release the button for the desired
light to turn the light ON or OFF. Press and hold
the button to set the desired light brightness.
The light will cycle between bright and dim
settings as long as the button is pressed. The
light key has an automatic auto-resume feature
that allows the light to remain at the same
brightness as the last time it was turned off. D. OFF-ON Slide Button (Wall Control Fans
Only)
This button turns the power Off and On to the
Fan and Light(s).
E. " " Button: (Full Function Remote Control
Units Only)
This button is used to change the direction of
the rotation of the blades; forward for warm
weather or reverse for cool weather.
NOTE: NOTE: If your Remote Control or Wall Control
does not have a " " button, Please look for a
slide reverse switch on the motor housing.
Remote Control only: Install a A23 12 volt battery (included). To prevent damage to transmitter remove the battery if not used for long periods of time.