Minka Group F510-WH - Manual (Page 17)

10
Fig 12
SCREWS
CONNECTORS
LIGHT PLATE
INSTALLING THE LIGHT PLATE
NOTE: Before starting installation, make sure power is turned off at the circuit breaker.
1. Remove 1 of 3 screws from the light kit mounting plate and loosen the other 2 screws. (Do
not remove)
2. Raise and hold the light plate close to the light kit mounting plate and proceed to do the
wire connections. Connect the white wire connectors from the light plate and fan, follow the
same procedure with the black wire connectors. (Fig. 12)
3. Place the key holes from the light plate over the 2 screws previously loosened from the
light kit Mounting Plate, turn light plate until it locks in place at the narrow section of the key
holes. Secure by tightening the 2 screws previously loosened and the one previously removed.
(Fig. 12).
LIGHT KIT
MOUNTING
PLATE