Minka Group F614-PW - Manual (Page 11)

Step 7. Slip Coupling Cover and Canopy onto Downrod. Carefully re-install the Hanger Ball onto
the Downrod being sure that it's properly positioned over the Cross Pin and the wires are not
twisted, tighten Set Screw. (Fig. 10)
Step 8. Lift the Motor Assembly and place the Hanger Ball into the Hanger Bracket. Rotate the
Motor Assembly as needed until the check groove from the Hanger Ball rests firmly over the
registration tab from the Hanger Bracket. Motor Assembly should not rotate if this is done
correctly. (Fig. 11)
HANGER BRACKET
Fig. 5
CEILING CANOPY
CANOPY BOTTOM
COVER