Magikitch'n MKH High Efficiency Griddle - Manual (Page 6)

Installation
MKH Series Gas Griddle
L25-053 Rev. 1 (12/11) 6
Figure 2
Figure 3
1.6. Installation Setup
The installation of this appliance MUST conform to
local codes. In the absence of local codes The gas
line must be installed to meet the local building
codes or National Fuel Gas Code ANSI Z223.1/
NFPA 54 Latest Edition, or the Natural Gas and
Propane Installation Code, CSA-B149.1 as
applicable, and local codes. To Start uncrate
appliance and locate installation accessories.
1.6.1. Counter Use With Legs
CAUTION
To prevent equipment damage, DO NOT tilt
your MagiKitch'n griddle on only two legs, or
on its sides.
(See Figure 2) A set of 4” legs is shipped with
the appliance (unless appliance was specifically
ordered without legs). A threaded insert for the
leg bolt is located near each corner of the
bottom appliance. Raise the appliance to allow
legs to be screwed tightly into inserts. The
appliance can be leveled by adjusting the feet at
the bottom of the leg assembly. This can be
done by turning the foot in or out to lower or
raise each corner as needed.
NOTICE
4" Legs should not to be used with the
Equipment Stand.
1.6.2. Counter Use Without Legs
(See Figure 3) The appliance must be sealed to
the counter to comply with applicable sanitation
standards. A bead of silicone sealant,
approximately ½ inch wide, is to be applied to
the bottom of the unit approximately ¼” in from
the front, back and side edges. We suggest Dow
Corning
→
, GE
→
or Permatex
→
silicone ‘RTV’
adhesive sealant or equivalent. (See NSF Basic
Criteria C-2 for details).
1.6.3. Equipment Stand
ATTENTION
Rear mounting brackets should be installed
to the Equipment Stand prior to placing
griddle on the stand.
CAUTION
Install the griddle so that the two locking
casters are at the front of the unit. The
casters should be LOCKED before the unit is
placed into operation.
(See Figure 4). To mount the griddle to the
stand, locate joining kit supplied with stand. The
joining kit should include (2) rear mounting
brackets, and (4) 1/2" mounting bolts. To mount
the griddle to the equipment perform the steps
on the following page:
IMPORTANT
The appliance must be level to perform
properly. Failure to level unit may result in
improper performance of the appliance.