Quick Cable 910 - Manual (Page 3)

Before using your portable power pack, you should fully charge it. The
fully charged indicator light will come on when the unit has been charged.
Recharge every 30 days or when the medium or low lights indicate less than
full charge. Fluctuations in temperature can accelerate battery discharge.
Check your unit often.
3
• Make sure the Rescue 900/910 power switch is OFF.
• Connect the red (positive +) clamp to the positive terminal or post on the
discharged battery.
• Connect the black (negative –) clamp to a ground away from the battery,
such as an alternator bracket.
• Turn the power switch
ON.
• Start the engine.
• Turn the power
switch OFF.
• Disconnect the
clamps, first negative
and then positive.
To jump start a vehicle or machine:
Using the Rescue 900 and 910
• Failure to keep internal battery charged will lead to permanent battery damage.
• Connecting a discharged battery to charged system could cause overheating or explosion.
• Damage may occur if the Rescue Portable Power Pack is attached to a running vehicle for
more than 30 seconds after the engine starts.
WARNING – Risk of Battery Explosion, Fire or Failure