Team Associated SC10.2 - Manual (Page 19)

19
:: Wheels / Tires and Body - Bag I - Step 1
:: Wheels / Tires and Body - Bag I - Step 2
:: Wheels / Tires and Body - Bag I - Step 3
Painting Tips:
Your vehicle comes with a clear polycarbonate body.
You will need to prep the body before you can paint it.
Wash the inside thoroughly with warm water and liquid
detergent. Dry the body using a clean, soft, lint-free
cloth. Use the supplied window masks to cover the
windows from the INSIDE of the body (RC cars get
painted from the inside). Using high quality masking
tape, apply tape to the inside of the body to create a
design. Spray (either rattle can or airbrush) the paint
to the inside of the body (prefferably dark colors first,
lighter colors last).
NOTE: use ONLY paint that is recommended for use
with (polycarbonate) plastics. If you don’t, you can
destroy the plastic body!!!!).
After painting, cut the body along the trim lines. Make
sure to drill or use a body reamer to make the holes
for the body mounts and antenna. The number plates
are located below the fender wells and the rear fins
are located below the bed section on the rear of the
body.
x4 6332
Body
clips
9876
SC10 Contender
Body
(clear)
x2
x2
6953
8-32
LP steel
locknut
6952
8-32
locknut,
steel
Carefully apply ca glue
to the tire bead.
Do one side at a time,
allow it to dry before
gluing the other side!
CA glue not included!
!
Tires / Inserts
not included! Tires / Inserts
not included!
91101
KMC hex
wheel, black
x4
#1597
ca glue