MEGUIAR'S MV81 - Manual (Page 4)

MV81, Velocity Mould Compound (19-17A): MV8101
__________________________________________________________________________________________
Page: 4 of 14
SECTION 7: Handling and storage
7.1. Precautions for safe handling
Avoid breathing of dust created by cutting, sanding, grinding or machining. Do not use in a confined area or areas with little
or no air movement. Do not breathe dust/fume/gas/mist/vapours/spray. Do not get in eyes, on skin, or on clothing. Do not
eat, drink or smoke when using this product. Wash thoroughly after handling. Avoid contact with oxidising agents (eg.
chlorine, chromic acid etc.)
7.2. Conditions for safe storage including any incompatibilities
Store away from heat. Store away from acids. Store away from oxidising agents.
7.3. Specific end use(s)
See information in Section 7.1 and 7.2 for handling and storage recommendations. See Section 8 for exposure controls and
personal protection recommendations.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
Occupational exposure limits
Ingredient CAS Nbr Agency Limit type Additional comments
Aluminium oxide 1344-28-1 Health and
Safety Comm.
(UK) TWA(as inhalable dust):10
mg/m³;TWA(as respirable
dust):4 mg/m³
Naphtha (petroleum),
hydrotreated heavy 64742-48-9 Manufacturer
determined
TWA:100 ppm
Health and Safety Comm. (UK) : UK Health and Safety Commission
TWA: Time-Weighted-Average
STEL: Short Term Exposure Limit
ppm: parts per million
mg/m³: milligrams per cubic metre
CEIL: Ceiling
8.2. Exposure controls
8.2.1. Engineering controls
Use general dilution ventilation and/or local exhaust ventilation to control airborne exposures to below relevant Exposure
Limits and/or control dust/fume/gas/mist/vapours/spray. If ventilation is not adequate, use respiratory protection equipment.
8.2.2. Personal protective equipment (PPE)
Eye/face protection
The following eye protection(s) are recommended: Safety glasses with side shields.
Skin/hand protection
Select and use gloves and/or protective clothing to prevent skin contact based on the results of an exposure assessment.
Consult with your glove and/or protective clothing manufacturer for selection of appropriate compatible materials.
Respiratory protection
Wear respiratory protection if ventilation is inadequate to prevent overexposure.
Select one of the following approved respirators based on airborne concentration of contaminants and in accordance with