Myron L 6PFCE and 4P - Manual (Page 28)

C. Clearing a Record/Memory Clear
After recalling a certain record location, press and HOLD to
clear that memory. This space will be the place for the next memory
record, unless you scroll to another empty position before ending the
recall sequence. The next memory stored will go into the next highest
available memory location.
Example: You have locations 1-7 filled and wish to clear the conductivity
reading stored in record location #3 and replace it with a pH reading.
1. Press and scroll to location #3.
2. Press and HOLD to clear old record #3.
3. Fill pH/ORP sensor well with sample.
4. Press to measure sample and press to store
reading in location #3.
5. The next memory stored will go into location #8.
6. To clear all records: After
Figure 10
MEMORY
pressing , scroll down.
“CL
r
ALL” will be displayed
(see Figure 10).
7. Press . All records will
be cleared.
X. TIME and DATE
The Time and Date may easily be changed as you travel.
A. Setting TIME
Figure 11
CAL
Time is always displayed in 24 hour
time.
Example shown in Figure 11, 16:05
equals 4:05 PM.
1. Press .
2. Press until the time is displayed (scrolling through
24