NaceCare Solutions ST580 - Manual (Page 12)

CLEANING THE SQUEEGEE
The squeegee must be in perfect working condition to achieve a good drying process:
it must be clean and its rubbers must be in good condition. Proceed as follows to
clean the squeegee:
•Remove it from the machine by pulling pin (1) out from column (2). Clean the
interior with a jet of water.
•Loosen knobs (3) remove block (4) and check that there is no dirt inside.
•Check the condition of the rubbers and replace them as necessary.
•Replace everything on the machine.
REPLACEMENT OF THE SQUEEGEE RUBBERS
Check the squeegee rubbers wear and if necessary, change them. To replace them:
•Take off the suction hose from its coupling.
•Take off the pin from the stud bolt.
•Remove the squeegee from its support.
•Remove the wing nuts which block the rubber blades and take them off.
•Replace the rubbers.
•To reassemble the squeegee repeat the above-mentioned operations.
MANUAL BRUSH REMOVAL
•Push lever (1) down to raise the base.
•Turn key (2) to OFF and remove it from the control panel (removing the brushes
with power on may cause injury to the hands).
•Rotate the brush, with the base raised, until it exits from the brush-bearing plate as
illustrated. The picture shows the direction of rotation for releasing the right brush.
Rotate in the opposite direction for the left brush.
•For single brush versions the procedure is the same and the rotation direction for
brush release is indicated on the picture.