頁面 8, Low cut, Flat – MIPRO ACT-80TC Rechargeable Digital Wideband Bodypack Transmitter User Manual

Page 8

AF LOW-CUT: Setup and Change of Low Frequency

Cut Off

a. Press MODE and stop on the AF LOW-CUT

function; the display showing the current status

will be flashing and is ready to be modified.

b. Press the SET button while the display is

flashing to change to LOW CUT or FLAT as

desired.

LOW CUT

AF LOW-CUT

FLAT

AF LOW-CUT

**Note:

When the AF LOW-CUT function is LOW CUT,

the frequency response below 100Hz will

decrease about 3dB with a slope of -

6dB/Octave.

Rechargeable Digital Wideband Bodypack Transmitter

**Note:

1. The higher the gains are set, the lower the

dynamic range for signal input and the

greater the danger of unwanted noises and

feedback getting into the system.

2. When using electronic guitar, gain should set

at 0dB.

3. Please make sure input signal strength does

not exceed 2 Vrms (gain=6dB) as it is the

maximum input strength allowed for

transmitter without causing distortion.

AF GAIN: Setup and Change of Input Sensitivity

a. Press MODE and stop on the AF GAIN function;

the display showing the current status will be

flashing and is ready to be modified.

b. Every push of the SET button increases the dB

value by 6dB to a maximum of 18dB.

0 dB

6 dB

-6 dB

12 dB

-12 dB

18 dB

AF GAIN