Fagor 6H-750BE User Manual
Page 25

e n g l i s h
23
4
Troubleshooting
You can solve the following problems yourself:
4.1 The oven is not heating up. Check it is
plugged in and switched on and that the fuse
has not blown. Select a higher temperature
setting.
4.2 The interior light is not working. Change the
bulb or replace the fuse.
4.3 Smoke is coming out during cooking. Turn
the temperature down and/or clean the oven.
Cleaning the outside of the glass: Use a
soft cloth soaked in a glass cleaning product.
Cleaning the inside of the glass: If the
inside of the glass is dirty, you can remove it
for cleaning.
When the oven has cooled down, open the
door as wide as possible (3.4.1) and fi x it
in place with the red stop supplied in the
accessories bag (3.4.2). Use the remaining
sheet accessory on one side of the glass to
raise up the glass like a lever. Do the same on
the other side of the glass. Remove the red
stop and close the door (3.4.3). Remove the
glass (3.4.4), clean it and dry it with a cloth
(3.4.5). If necessary, remove the whole glass
panel unit inside the door. This unit consists
of either one or two glass panels, depending
on the model, with a black stop in each
corner. To remove them, place your hand
under the door and pull upwards (3.4.6).
When you have taken out the unit, remove
the stops to clean the glass panels (3.4.7).
When the glass panels are clean (3.4.8) fi t
them onto the rubber stops again, with the
stud facing upwards (3.4.9) and replace the
glass panels so that the letters “L” (left) and
“R” (right) are beside the hinges (3.4.10).
Lastly, place the remaining glass panel so
that the word PYROLYTIC can be read
(3.4.11). Remove the stops (3.4.12) and
close the door.
Warnings:
• Make sure the oven is switched off.
• Allow the glass to cool down before
removing it.
• Never use steam cleaning machines.
3.5 Cleaning the outside of the oven. Use
neutral cleaning products. Dry the oven well
with a soft cloth.
4.4 The pyrolysis cleaning process is not being
carried out. Ensure the door is correctly
closed. Locking system or temperature
sensor failure. Call the Technical Service.
4.5 A beep is sounding. The selected
temperature setting has been reached. The
cooking cycle is complete.
4.6 The oven makes a noise after cooking. This
is normal, as the fan keeps running until the
temperature inside and outside the oven is
reduced.
4.7 Failure warnings.
Temperature sensor failure.
Do not try to repair the oven yourself. Call
the technical assistance service.
5
The Environment
This oven has been designed with
environmental protection in mind.
Respect the environment. Only preheat the
oven when necessary (see table). Use dark
coloured cake tins whenever possible. For
long cooking times, switch off the oven 5 or 10
minutes before the end of cooking time.
Management of waste electrical and
electronic equipment.
The symbol
indicates that the appliance must
not be disposed of in traditional bins for domestic
waste.
Take your oven to the a special collection centre.
Recycling domestic appliances will prevent
negative consequences for health and the
environment and will allow savings on energy and
resources.
For further information, contact the local
authorities or the shop where you bought the
oven.