DiGiCo SD Rack - Manual (Page 13)

SD Rack
1-13
1.6.14 Rack Main and Aux Splits .................................................
This page controls the Main (MadiSM) and Aux (MadiSX) MADI Split functions.
1) Each split can be < OFF >, < ON > or ON with automatic Gain Tracking enabled (< GT >).
2) The sample rate of the split signal can also be set to be either the same as the rack's current sample rate < SYS > eg 96Khz or
< SYS/2 > which is half of the rack's current sample rate. eg Rack at 96KHz and split at 48KHz.
3) The MADI Type of the split can be set to standard 56 channel < 56ch >, 64 channel < 64ch > or < SD rck > which will emulate the
output of the SD rack and be recognised as such by the receiving MADI device. This last type would be useful if the split was feeding an
SD series console.
1.6.15 Rack Card Splits .................................................................
This page controls the individual output card Split functions.
Each card split can be < OFF >, < ON > or ON with automatic Gain Tracking enabled (< GT >).
Each input slot (block of 8 sockets on an input card) can be split to its relevant output slot. So slot 1 would be split to slot 8, slot 2 to slot 9
and so on.