DiGiCo EX-007 - Manual (Page 6)

EX-007 User Manual
Page 6
1.5 Mirroring Mode ........................................................................
Mirrored devices may operate in one of 3 different modes which are set in the Master screen / Options / Session tab.
Mirroring Modes are:
1) Full Mirror - normally used between two SD-7 engines where all functions are mirrored to ensure that the two sessions remain in
complete sync.
2) Expander - used when the EX-007 is considered to be part of the console and requires all the same options to be set.
The difference between Full Mirror and Expander modes is that in Expander mode the selection of banks and layers is not Mirrored and
therefore different channels can be viewed independently on the two devices.
3) Remote - used when the EX-007 is considered to be a seperate unit that is used as an additional worksurface possibly operated by a
second person. In this situation all options can be set independently and banks and layers can also be viewed independently on the two
devices.
1.6 Worksurface Layout ................................................................
When the SD7 and the EX-007 have been synced and mirrored they will both have the same worksurface layout but normally you will wish
to view different banks on the two devices. All banks are available on both devices in the same way so the general layout should be
considered carefully.
As a starting point we would suggest that the EX-007 is set to view Layer 3 and the banks that are required on the EX-007 are assigned to
Layer 3 using the Fader Banks panel in the Layout menu using either the Copy To or Move functions.
Touch the relevant on screen bank button, touch either Move or Copy To button and then touch the relevant destination bank in Layer 3.
In the picture below, you will see the result of moving banks containing CH 25-36 and CH 37-48 to left and right hand banks of Layer 3.
These could then be viewed on th EX-007.