DiGiCo SD9 - Manual (Page 26)

SD9 - Getting Started
1-21
1.12 Solo Setup
The SD9 Solo panel is accessed from a button at the top of the Master Screen. Some of the controls on this panel are duplicated
on the left worksurface section.
There are two solo busses and each channel on the consoles can be independently assigned to use Solo1, Solo2 or Solo 1+2.
Therefore, if the console was being used for Stage monitors, the first solo buss could feed “In-Ear” monitors, and the second solo
buss could feed a wedge.
Solo Trim
Solo Delay
Solo 2 / Master - Fader Assignment
Direct Out Level Floating Meter
Display On
Solo Level
Mono / Stereo / Surround switch
No solo source select
Insert routing
Direct Out routing
Headphones On / Off
Clear
multi / single solo mode
pfl / afl solo mode
The following functions are available independently for each solo buss :
- Mono / Stereo/Surround Switch
- No Solo source routing
- Insert Point with both internal and external routing capability
- Direct Out routing (eg. for feeding a wedge)
- Assignment of worksurface rotary to either Solo 2 Master or Main Buss Master
- afl or pfl mode
- single or multi solo mode
- Delay
- Level Trim
- Auto solo mode
- Floating Meter
No Solo : Source for solo buss when no channel is in solo mode. No Solo source does not show on Solo meters.
Auto Solo : If a channel is set to Auto Solo, it will automatically solo when another channel is soloed. The Auto Solo function of each solo
buss can be enabled and disabled as required. The solo buss must be in multi mode for the auto solo function to operate.