CertainTeed 2823_QR510 User Manual
Quietrock 510 installation instructions, Using quietrock
![background image](/manuals/460117/1/background.png)
QuietRock 510 Installation Instructions
Copyright © 2010 Serious Materials
Distributed in Canada by:
Professional: 800-233-8990 • Consumer: 800-782-8777
QuietRock 510 Installation Instructions
Read all instructions before installation. Remember: Safety first!
QuietRock is very similar in use to standard drywall. The panels have been used in 1000’s of
successful projects, large and small, and require little additional labor or training versus standard
drywall. Remove all edge tape before use.
• Hang QuietRock like standard drywall
• Score panel deeply on both sides, snap down over a straight edge, cut paper beneath score line
• QuietRock 510 panels weigh about the same as standard 12.7 mm (1/2") drywall
• No special labor is required to install QuietRock 510
• No special training is required to install QuietRock 510
• No resilient channels, or clips are required with QuietRock.
• Finish the same as standard drywall (mud, tape, texture and paint are all the same)
• When used properly, QuietRock may provide 15 to 20 dB more isolation when compared to
standard drywall. See tested assemblies and solutions (separate document) for specific details.
NOTE: As with all drywall products, hang QuietRock immediately or store flat it in a dry location.
Protect the QuietRock materials from exposure to moisture during the construction or remodeling
process, from product storage to project completion. Moisture or water can cause problems with
any drywall product, including QuietRock. Do not cover with plastic for extended periods, as that
may allow condensation. To complete the installation of QuietRock and maximize its acoustic
performance, it is recommended that you use QuietSeal between the interior joints and QuietPutty
in any penetrations such as electrical outlets, HVAC ducts, water hookups and cables. Not using
QuietSeal and QuietPutty may compromise the acoustical results of the installation.
The QuietRock line of engineered products is a sound isolation panel designed to replace standard
drywall in any wall, including wood and metal studs, and as the base layer on a ceiling with a 15.9
mm (5/8") panel applied over it. QuietRock 510 is a multilayer gypsum board product which includes
highly engineered internal sound damping layers which provide dramatically increased transmission
loss. QuietRock can be used with a variety of standard framing techniques including single, stag-
gered and double stud construction. You may use QuietRock panels similarly to other 12.7 mm (1/2")
gypsum wall products. The panels can be snapped, drilled, cut and attached to the frames. Please
completely read these instructions bellow before beginning installation and be sure to always follow
all OSHA safety guidelines when installing any Serious Materials product. As with any other acousti-
cally treated assembly, all air gaps and penetrations must be treated with non-hardening acoustical
sealant and putty pads as specified by the manufacturer.
Using QuietRock
SCORE AND SNAP:
1) QuietRock 510 may be scored with any utility blade. We have found that the best blade is the
Irwin Blue Blade (available at most building supply dealers).
2) Score QuietRock 510 deeply (2 times to a depth of 6 mm (1/4") on one side, making sure to cut the
paper in the center of the board, and snap against a straight edge.