Beijer Electronics iX Panel K60 EN - Manual (Page 23)

Hardware Replacement
7. Insert the two screwdrivers between the display frame and the aluminum
casing illustrated below. Press and bend gently on the display frame to unlock
the frame and tilt up the display frame.
display frame pressure points
8. Mount the new display unit.
9. Re-assemble the panel in reverse order.
7.4.1 Self-test of the Display
To perform a self-test of the display, follow the steps below:
1. Start the operator panel in a self-test mode (see table in the
Mode Switches section).
2. Go to the display test. Verify that the display works.
3. If the screen does not work, try fault tracing, see the
Fault Tracing section.
Beijer Electronics, MAEN001 23