Beijer Electronics iX Panel T40 EN - Manual (Page 19)

Hardware Replacement
7 Hardware Replacement
This section contains instructions on how to replace operator panel hardware.
Only components included in the latest bill of material and spare parts list are
allowed. See
Available Spare Parts for iX Panel T40 .
7.1 Mode Switches
The iX Panel T40 has four mode switches (DIP switches) located on the rear side
of the operator panel.
1 2 3 4
ON DIP
1 2 3 4 ON DIP
Warning:
The modes below are to be used with caution.
The mode switches have the following functions: 1=ON, 0=OFF
Each letter in “MODE” has a corresponding mode switch.
MODE Description
0000 “Run mode” - boots CE, normal operation.
0010 System Restore, resets the file system and registry,
reinstalls the system program (OPsys_bxxx.CAB). Restores
the operator panel to factory settings.
Warning! Information can easily accidently be lost.
0100 Image Load mode (Sysload) allows upgrading of the
firmware in the operator panel.
Note: All files including the file system in the operator
panel will be deleted when upgrading with Image Loader.
1000 Service Menu mode, the service menu for the system
program is shown. Allows the user to set IP configuration,
erase the project, calibrate the touch screen etc. See
section
Service Menu for details.
1100 Not used (run mode).
Beijer Electronics, MAEN004 19