Beijer Electronics EPC TA150 AM EN - Manual (Page 5)

Safety Precautions
1 Safety Precautions
Both the installer and the owner and/or operator of the Panel PC must read and
understand this installation manual.
1.1 General
• Read the safety precautions carefully.
• Check the delivery for transportation damage. If damage is found, notify the
supplier as soon as possible.
• Do not use the Panel PC in an environment with high explosive hazards.
• The supplier is not responsible for modified, altered or reconstructed
equipment.
• Use only parts and accessories manufactured according to specifications of
the supplier.
• Read the installation and operating instructions carefully before installing,
using or repairing the Panel PC.
• Never allow fluids, metal filings or wiring debris to enter any openings in the
Panel PC. This may cause fire or electrical shock.
• Only qualified personnel may operate the Panel PC.
• Storing the Panel PC where the temperature is lower/higher than
recommended in this manual can cause the LCD display liquid to
congeal/become isotopic.
• The LCD display liquid contains a powerful irritant. In case of skin contact,
wash immediately with plenty of water. In case of eye contact, hold the eye
open, flush with plenty of water and get medical attention.
• The figures in this manual serves an illustrative purpose. Because of the many
variables associated with any particular installation, the supplier cannot
assume responsibility for actual use based on the figures.
• The supplier neither guarantees that the Panel PC is suitable for your
particular application, nor assumes responsibility for your product design,
installation or operation.
1.2 During Installation
• The Panel PC is designed for stationary installation on a plane surface, where
the following conditions are fulfilled:
–
no high explosive risks
–
no strong magnetic fields
–
no direct sunlight
–
no large, sudden temperature changes
• Install the product according to the accompanying installation instructions.
• Ground the product according to the accompanying installation instructions.
• Only qualified personnel may install the Panel PC.
• Separate the high voltage, signal and supply cables.
• Make sure that the voltage and polarity of the power source is correct before
connecting the product to the power outlet.
• Peripheral equipment must be appropriate for the application and location.
Beijer Electronics, MAEN044 5