Beijer Electronics iX TxA EN - Manual (Page 14)

TxA Maintenance
3.2.6 Replacing the Display/Display Cable
The following is needed:
• A new display— including front adapter board, display frame and a new
display cable
• A Torx TX10 screwdriver
• Phillips screwdriver
Note:
Make sure to use adequate ESD protection.
Information about spare parts can be found in chapter Available Spare Parts .
Follow the steps below:
1. Power off the operator panel.
2. Follow the instructions in chapter
Replacing the Back Cover and/or CPU Card to remove the back cover.
3. Unlock the flex cable connector and disconnect the flex cable from the
CPU board.
Note:
The connector must be unlocked on both sides before removing the cable.
4. Disconnect the LED flex cable from the Front Adapter Board.
Beijer Electronics, MAEN021 14