Ultra space saver – American Bicycle Security Company Ultra Space Saver User Manual
Page 5
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
*Tools Needed for Wall Mount Installation
9/16” Wrench/Socket
3/8” Masonry Drill Bit
Tape Measure
Drill (Hammer drill recommended)
Hammer
1. Measure out space. Attach feet to uprights with carriage
bolts provided. See figure 1.
2. Lay assembled uprights with crossbeams attached on
their side so crossbeams are facing up. Slide first hanger
arm on. Then slide the plastic spacers on. See figure 2.
3. Slide next arm on but make sure to stagger height of
each arm so that the hanger rod is at a different level
from its neighboring arms. For double sided model slide
arms on opposite each other. Repeat until the crossbeams
are full. For Single-sided installs place 3” spacer at end
(part# SS-Spacer-3”) See figure 3.
4. Tip rack up and attach the second upright. Tighten bolts.
Slide assembled rack into final location. For add-on units
repeat steps. See figure 4.
5. Anchor rack to floor with 3.75” wedge anchors. See figure 5
Ultra Space Saver
Installation
Installation Steps: