Ultra space saver – American Bicycle Security Company Ultra Space Saver User Manual
Page 3
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
The Ultra Space Saver has several steps for
installation. Note that the single and double sided
setups and parts are different. Make sure you follow
the instructions according to the model you ordered.
Recommended Base materials:
Solid concrete is the best base material for
installation. Make sure nothing is underneath the
base material that could be damaged by drilling
(i.e. post-tension cable). Use the 3.75” wedge
anchors that are included to install the
rack into the concrete (wall anchors are 3”).
Installation:
Sort out the parts to the rack and identify each of
them accordingly. The 1” carriage bolts are for
assembly of the rack and the 3.75” wedge anchors
are for mounting the rack to the floor.
Reading your designed
layout
Ultra Space Savers come in
varying configurations, making it
very important that you
carefully follow the layout
provided when installing the
racks.
If you do not follow the diagram,
you may well end up short of
parts. The length of each Ultra
Space Saver unit is indicated by
a number ranging from B2-B7 in
the layout. This number
corresponds to the length of
crossbeams to be installed. In
the example provided below the
Ultra Space Saver is to be
installed starting
with two B4 units, which have
44” crossbeams, followed by a
B5, which has 76” crossbeams.
Ultra Space Saver
Installation