Pocket shelter – American Bicycle Security Company Pocket Shelter User Manual
Page 9
American Bicycle Security Company
P.O. Box 7359
Ventura, CA 93006
Ph: (800) 245-3723 or (805) 933-3688
Fax: (805) 933-1865
Pocket Shelter
Panels Assembly
1. SIDE PANELS
If using side panels, place the PANEL with the single pre-drilled hole oriented towards the top. Align the pre-
drilled hole and the corresponding pilot hole in the shelter and secure with a ¼” x 1” self-drilling screw. Confirm
that the PANEL is aligned with the shelter and not bowed. The next self-drilling screws will drill through the PANEL
and into the pilot holes at locations 2 and 3. Continue with the next 18 self-drilling screws while working from the
center outwards. Repeat for the other side of the shelter.
2. REAR PANELS
If using rear panels, place the PANEL with the single pre-drilled hole oriented towards the top. Align the pre-
drilled hole and the corresponding pilot hole in the shelter and secure with a ¼” x 1” self-drilling screw. Repeat
for the next (2) rear PANELS. Confirm that the PANELS are aligned with the shelter and each other and not
bowed. The next self-drilling screws will drill through the PANEL and into the pilot holes at locations 2, 3, and 4.
Continue with the next 24 self-drilling screws in each PANEL while working from the center outwards.