Power Soak 33638 SILVERWARE WASHER OWNER'S MANUAL - Manual (Page 30)

30
Symptom
Possible cause Remedy
Silverware
is not
getting
clean Unit is being filled with
cold water
Pieces are nesting
Too much food soil is
being left on the
silverware when the
basket is loaded
Food soils are dried
onto the silverware
before being loaded
into the basket
Basket is being
overloaded
Ineffective detergent
is being used
Low water level
Exhausted detergent
Insufficient detergent
Insufficient wash time Drain and refill with 115
o
F water.
Avoid sorting the pieces by type, e.g. all
spoons being washed, followed by all forks
being washed, etc.
Rinse off heavy accumulations of food soils
before the pieces are loaded into the
basket. This will avoid weakening the
detergent.
Allow the silverware to pre-wash for a
longer period of time.
Remove silverware until the level is at or
below the fill line inside the basket. Spread
the silverware out into a uniformly thin layer
on the basket bottom. Do not allow the
silverware to remain in a thick pile.
Consult with your chemical supplier to
determine the best chemical for your
application.
Water level should be even with the fill line
inside the basket when the unit is off.
Drain the unit and refill it with fresh
detergent and 115
o
F water. Experiment
with refreshing the water and detergent
more often.
Follow the chemical supplier's instructions
exactly for best results.
Highly intricate silverware and stubborn
soils will require extra wash time.