Power Soak 33638 SILVERWARE WASHER OWNER'S MANUAL - Manual (Page 14)

14
Mechanical Installation of Built-in Units
The installation and initial operational
check of your new system must be
performed only by licensed and certified
plumbers and electricians.
Be sure to follow all applicable national
and local electrical codes when installing
the electrical supply for your system.
Be sure to follow all applicable national
and local sanitation codes when
installing your system.
Both the Drop-in and the Weld-in versions of the Power
Soak Silverware Pre-washing System are designed to be
installed in existing dish tables. Installation of both types is
very similar with the main difference being that the Drop-in
version requires no field welding.
Before beginning the installation, review the drawing that
ships with the unit to confirm that the location chosen for
the system is adequate with respect to:
• Drain proximity
• Electrical power proximity
• Adequate space on the dish table top for the tank
and the faucet