Power Soak 37099 PS-201 Owner's Manual - Manual (Page 20)

16
Facility Owner/Manager Section
The only troubleshooting procedure that the facility
owner or manager can perform is listed immediately
below. All other procedures must be performed by an
authorized service agency. To obtain the name of a
recommended service agent in your area, please call
the Power Soak Service Department at 800-444-9624.
LED Status on Control Panel Overlay
It is recommended that the condition of the system be verified by first
observing the “STATUS” LED’s on the front of the control panel. If
necessary, take corrective action prior to performing any further
troubleshooting.
Green Light
Slow Flashing – “POWER ON” – system is energized and ready to fill.
Solid Illumination – “READY” – wash sink is full; system is ready.
Blue Light
The blue light is not used with the PS-201 control system
Red Light
The red light is not used with the PS-201 control system.
(located under the green “Start” button)