Pitco Frialator Pasta/Rethermalizer Digital Controller - Manual (Page 2)

Press , Display will show "LOC or Pr09" (Program)
If display shows "LOC" Press then , This will unlock the
programming function and allow changes to be made to settings
Press , Display will show "Pr09" (Program) the indicator lights above both
Press and hold for 2 seconds, display will show "XXXF" you are now in
SIMMER MODE TEMPERATURE PROGRAMMING (XXXF = current set
temperature for the simmer mode)
NOTE: Press and hold to save setting or exit at any time in the programming
sequence.
Press the or function keys to change set temperature
Press , Display will show "T 1 or T 0" (T 1 = actual temperature always
appearing display window, T 0 = SIM or BOIL will always appear in display window
when controller is operation mode)
Press , Display will show "LOC or ULOC" (LOC = turns pass word function
ON so that a pass word is required to enter programming mode, ULOC = turns pass
word requirement OFF)
Press , Display will show "LIF1 or LIF2" (LIF1 = tells the controller that
cooker has only a single basket lift, LIF2 = tells the controller cooker has two basket
lifts)
and functions key will illuminate.
*
*
*
*
*
*
*
*
*
UPPER LEVEL PROGRAMMING INSTRUCTIONS
LIF1
ULOC
LOC
T 1, T0
P P
P P
P P
P P
P P
P P
P P PROGRAMMING
PASSWORD
SIMMER MODE
TEMP
SAVE / EXIT
ACTUAL
TEMP
DISPLAY
PASSWORD
SET
BASKET
LIFT
TO SAVE SETTINGS OR EXIT PROGRAMMING
NOTE: Press and hold to save setting or exit at any time in the
programming sequence.
P P
*
Indicates controller is under temperature set point and burners are on
Indicator light, when illuminated, indicates burners are on
Indicates unit is in boil mode
Indicates unit is in simmer mode
Boil
S I M
_ . _ _ F
_ . _ _ F