Nor-Lake Large Capacity CO2 Incubator - Manual (Page 5)

CO
2
Sample Port
The chamber atmosphere can be taken from the Sample Port located at the bottom of the front
control panel. CO
2
concentration can then be checked using a FYRITE gas analyzer or other
instrument such as a gas chromatograph.
Humidity Pan Option (CO
2
Incubators only)
The Large Capacity Incubator humidity pan is manually filled with water as required. Humidity
(moisture) is introduced into the incubator interior by evaporation only.
The humidity pan is 22 Ga. stainless steel with dimensions of 20-3/4 inches long x 12-3/4 inches
wide x 2-1/2 inches deep. The pan capacity is 9 quarts (8.52 liters). A stainless steel pan cover is
also supplied.
Note: With the CO
2
/humidity pan feature, the cabinet is also provided with a drip pan that mounts
under the door. The drip pan catches any condensation that drips during door openings. The drip
pan is supplied with 4’ of 3/8” ID tubing and a 3/8” drain stopper. Tubing must be connected to
adequate drain or stopper needs to be installed and accumulated moisture removed as needed.
5 11/10 Rev. B 143314
Figure B
Drawer Option
The Large Capacity Incubator is offered
with drawers as an option.
Drawer Removal – The Large Capacity
Incubator may accommodate up to eight
drawers. To remove the drawers for
cleaning, locate the black release tabs
found on the inside front of the drawer. See
Figure C. Push the release tabs on each