Nor-Lake Undercounter & Freestanding Refrigerators - Manual (Page 3)

• Check the resting of the magnetic seals. The seal must not be creased thereby
ensuring a good seal.
1 Upper hinge pin 5 Corner element bung with a hole
2 Lower hinge 6 Kick plate
3 Kick plate and / or switch-board 7 Door bearing
4 Handle 8 Two nuts of lower hinge
Figure 4
Bulb Replacement
Before replacing the light bulb, disconnect the refrigerator from the power supply. Press the cover at
the rear side (in the arrow 1 direction) and remove the plastic cover (in the arrow 2 direction).
Replace the bulb with a new one (E14, 10W maximum).
MAINTENANCE
PERIODIC CLEANING
Disconnect the power supply before cleaning the refrigerator.
Beginning with the initial installation, the interior surfaces of the cabinet should be periodically
wiped down with a solution of warm water and baking soda. This solution will remove any odors
from spillage that has occurred. The exterior of the cabinet should also be cleaned frequently with
warm water and a mild liquid detergent. Caution: Do not use an abrasive or alkaline solution.
Monthly cleaning of the condenser will aid the heat transfer characteristics of the refrigeration
system and increase its efficiency. Dust, dirt, and lint will tend to accumulate on the condensing
unit. Any obstruction will affect the flow of air through the condenser, thereby lowering the efficiency
3
9/09 133288