EXONIC EXD 4500T - Manual (Page 18)

18
Reset Factory Settings
RESET button is placed on the housing
and must be activated with either a
ballpoint pen or thin metal object.
The RESET button is to be activated for
the following reasons:
Basic Operation
Balance:
Fader:
R 0-10 to L 0-10 .
Adjust sound balance between left
and right speakers by using VOL + / -
F 0 10 to R 0 -10 .
Adjust sound balance between front and
rear speakers by using VOL + / VOL - .
.
-
FM1 106.30
MHz
ST DX
LUD SWF POP 11:08AM
In Radio mode:
You can adjust your desired scroll
caption , the method of the operation
as follow:
a). Press and hold the SETUP button
(for about 2 seconds) on the remote
control, the adjustment scroll bar
will display on the screen .
b). Use the VOL+/- to select among of
the “A, B, C ....X, Y, Z, and blank ”,
and use the / button on the
front panel to ahead/back (proceed/
cancel) , and then press the SETUP
button briefly to confirm .
Scroll Caption Adjustment
NOTE:
If RESET is selected, all memory data
will deleted, please re-adjust .
A. Initial installation of the unit when
all wiring is completed.
B. All the function buttons do not operate.
C. Error symbol on the display.
RET
TOUCH SCREEN
RESET
Touch the screen the DSP range
(or press the EQ/LOUD button
on the remote ) to select one of
the preset sound modes .
(Rock/Pop/Jazz/Classic/Flat) .
The information will display in the
monitor as follow :
Setting Audio Modes
It`s depend on your habit to select the Audio mode .
POP
FLAT
ROCK
CLASSIC
JAZZ
DSP
OSD
CLK DSP
RDM INT RPT
LUD SWF POP 11:08AM
DISC IN
DVD 11-0:44:36
RPT
ZOOM LUD SWF
touch to select
(Press it button longer again to renew . )