beautypg.com

If this message appears – Alpine NVD-A802 User Manual

Page 83

background image

80

-EN

ALPINE NVD-A802 68-06194Z86-A (EN)

If this Message Appears

Various messages are displayed on the screen during operation. In addition to the messages telling you the current status or providing
guidance for the next operation, there are also the following error messages. If one of these error messages is displayed, carefully follow
the instructions in the solution column.

Cause

• The disc has been removed.

• There was no disc in the system

when the power was switched on.

• A disc that this system cannot

read has been loaded.

• The disc is dirty or upside down.

• The disc cannot be read because

of condensation.

• The MENU button was pressed

while the vehicle was running.

• A menu selection operation was

carried out while the vehicle was

running.

• The inserted DVD-ROM does not

cover the map display region or

map display region needs to be

changed to the correct region in

Setup (if map region exists in

Source Disc).

• The destination is outside the map

display region and not contained

in the inserted DVD-ROM.

• Ambient temperature over 122ºF

(50ºC)

• Application error

Message

Please insert DVD-ROM.

Error reading DVD-ROM.

Please check the disc.

If you are driving, please pull

over before using this

function.

Vehicle is out of Map display

region.

Please refer to the Owner's

Manual.

Destination is out of Map

display region.

Route cannot be calculated.

Temperature is too high.

Please allow system to cool

down.

Update failed.

Please check your disc.

Solution

Insert the disc.

Take out the disc, check if it was upside down,

clean it if necessary, then reinsert it.

Take out the disc, allow enough time for the

condensation to evaporate (about 1 hour), then

reinsert the disc.

Move the vehicle to a safe location, stop, and

engage the parking brake, then carry out this

operation.

Insert the DVD-ROM that applies to the current

map display region. If map region exists in the

Source Disc, change Map display region in Setup

to the correct region.

Insert the DVD-ROM in which the destination is

registered and contained in the map display

region.

Lower the temperature in the vehicle below

122ºF (50ºC), for example by running for a while

with the window open or by using the air

conditioner.

If the South disc is inserted, replace it with the

North disc.

The application starts updating.