Connection for the auto time adjustment function, Connection of the control output – Panasonic WJ-NV200 - User Manual

Page 27

Connection for the auto time adjustment function

When a signal output from the other device is supplied to the time adjustment signal input (pin no. 20) and the time difference
between the recorder and the other device is 29 minutes or less, the clock of the recorder will be set to the time set for the other
device.
When a signal output is supplied to the recorder 29 minutes before/after the hour, the clock of the recorder will be set to the hour
(nn:00:00). ("nn" is the hour.)
Example:
• Signal is supplied at 2:50:00 pm → Set at 3:00:00 pm
• Signal input supplied at 3:28:45 pm → Set at 3:00:00 pm
• Signal is supplied at 3:29:30 pm → Time will not be adjusted.

Note:

• When adjusting the time using the time adjustment signal input, select "On" for "Auto time adjustment". (☞ Page 42)

Connection of the control output

When an alarm device such as a buzzer or a lamp is connected, the signal output from pin no. 20 and pin nos. 15 - 19 can be
used to notify the status by sounding a buzzer or lighting a lamp.
The connection example of the HDD error output (pin no. 16) is as follows.

Signal gr

ound

Sensor signal input

Alarm input

Alarm r

eset input

Series r

ecor

ding output

Time adjustment signal input

Signal gr

ound

Alarm output

Alarm r

eset output

Alarm r

ecor

ding

During r

ecor

ding

Disk

Buzzer output

System err

or output

Thermal err

or output

Time adjustment signal output

Series r

ecor

ding output

Output for the

indicators on

the front panel

Terminal of the other device

ALARM/CONTROL

(Signal ground)

(Time adjustment signal input)

(Signal ground)

(HDD error output)

ALARM/CONTROL

Alarming device

* Attached when necessary

Relays, etc.*