Aastra Telecom ATP-CNX-020 - Manual (Page 23)

Procedures
ATP-CNX-020 Rel. 1.2, Doc. Rev. 01.06 9
Aastra CNX Installation and Setup Procedures
(1) Run network and time configuration
Use the following procedure to initially configure the network settings on the Aastra CNX
hardware.
Step Action
1 After first-time power up of the CNX, the following displays in a terminal window:
Welcome to the
Aastra CNX - Conference Bridge
Configuration Utility
- please press to continue -
2 Press .
The following displays:
Hostname:
3 Enter the hostname for the Aastra CNX and press . For example:
Hostname: cnx1 ↵
The following displays:
Configuring ENET #1...
IP Address:
4 Enter the IP address for the Ethernet port for which you want to use as a management interface, and
press . For example:
IP Address: 192.168.2.6 ↵
The following displays:
Netmask:
5 Enter the Netmask for the Ethernet port for which you want to use as a management interface, and
press . For example:
Netmask: 255.255.255.0 ↵
The following displays:
Default Gateway:
(continued)